Heater B Gold Hire Option Instructions
Connect the bent short priming pipe to the outlet pipe on the on the left of the heater (if facing heater).
Make sure the washer is in each of the outlet pipes on the heater.
Connect the short straight priming pipe to the inlet on the right of the heater (if facing heater).
Fill the long inlet pipe with water.
Loosely attach the long inlet pipe to the short straight priming pipe.
Fill the bent short priming pipe with water until you see water coming out of the join between the short straight priming pipe and the long inlet pipe.
Tighten the union between the short straight priming pipe and the long inlet pipe.
Move the heater away from the pool. Sumbmerge the filter chamber in the pool and replace the short bent priming pipe with the filter chamber.
Remember the short bent priming pipe has water in it so be careful not to get yourself wet.
Attach the long outlet pipe to the filter chamber. Both long pipes should hang over the edge of the pool into the pool.
When the water in the pool covers the bulbous end of the inlet pipe you can plug in the heater. Plug the heater in using the RCD circuit breaker and press reset. The control panel will come on.
